ch = interrupt channel number (pls refer to PLC installation guide) fn_num= Custom Function number to execute when interrupt pin changes according to the defined edge. This is the Interrupt Service Routine ISR. edge = Positive number means rising edge-triggered. 0 or negative number means falling-edge triggered.
ch = interrupt channel number (pls refer to PLC installation guide)
fn_num= Custom Function number to execute when interrupt pin changes according to the defined edge. This is the Interrupt Service Routine ISR.
edge = Positive number means rising edge-triggered. 0 or negative number means falling-edge triggered.
Basic to TBASIC Reference Manual
Basic to TBASIC Reference Manual Basic to TBASIC Reference Manual